No Answer-Back
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
In some cases, wireless door lock control functions are normal but the hazard warning lights answer-back function does not operate. In such cases, the main body ECU's hazard warning lights signal outputs may be malfunctioning.- NOTICE:
- Troubleshooting should be started after confirming that the customize status of the answer-back function.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRELESS DOOR LOCK CONTROL FUNCTION |
Check the wireless door lock control functions by operating the transmitter switches.
Result: Result
Proceed to
Wireless door lock functions are normal but hazard warning light answer-back does not occur
A
Wireless door lock functions are abnormal
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FLSH RELAY, TURN SIGNAL FLASHER RELAY) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the hazard warning lights flash.
Main body ECU: Item
Test Details
Diagnostic Note
Hazard
Turns FLSH relay*1 (turn signal flasher relay*2) ON / OFF
-
- HINT:
- *1: for LHD
- *2: for RHD
- OK:
- Hazard warning lights are turned ON / OFF
|
|
||||
| NG | |
| 3. CHECK HAZARD WARNING LIGHT |
Check that the hazard warning lights flash continuously when the hazard warning signal switch is pressed.
Result: Result
Proceed to
Hazard warning lights flash continuously (for RHD)
A
Hazard warning lights do not flash continuously
B
Hazard warning lights flash continuously (for LHD)
C
|
|
||||
|
|
||||
| A | |
| 4. CHECK WIRE HARNESS (MAIN BODY ECU - TURN SIGNAL FLASHER RELAY) |
![]() ![]() |
Disconnect the IT junction block connector.
Disconnect the E81 flasher connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
IT8-7 (HAZ) - E81-8 (HAZ)
Below 1 Ω
IT8-7 (HAZ) or E81-8 (HAZ) - Body ground
10 kΩ or higher
|
|
||||
| OK | ||
| ||

