2005-2008 RAV4 · Service Manual SECURITIES

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM

B129962E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B2)
  1. Remove the ECU-B2 fuse from the No. 2 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)

  1. B110782E10
    Disconnect the E50 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E50-16 (GND) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    E50-1 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Security Indicator Light Circuit (from Nov 2005)INSPECTION (from Nov 2005) →