2005-2008 RAV4 · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSPECT UNDERDRIVE PACK CLEARANCE
  1. Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. D008123E01
    Install a dial indicator as shown in the illustration.

  1. D008124E01
    Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    1.51 to 1.90 mm (0.0594 to 0.0748 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.


2. REMOVE NO. 1 UNDERDRIVE CLUTCH DISC

  1. D008125E01
    Using a screwdriver, pry out the snap ring.

  1. C129394
    Remove the flange, 3 discs and 3 plates from the underdrive clutch drum.


3. INSPECT NO. 1 UNDERDRIVE CLUTCH DISC

  1. D004077E01
    Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


4. REMOVE UNDERDRIVE CLUTCH PISTON SET

  1. D003703E02
    Place SST on the clutch balancer and compress the spring with a press.
    SST
    09350-32014   (09351-32070)

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
    2. This prevents the spring sheet from being deformed.
    3. Do not expand the snap ring excessively.

  1. D003704E01
    Remove the clutch balancer and piston return spring from the underdrive clutch drum.

  1. D008127E01
    Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. D008128E01
    Holding the underdrive clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle case to remove the underdrive clutch piston.


5. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D009214E01
    Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    17.14 mm (0.6748 in.)


6. REMOVE UNDERDRIVE CLUTCH DRUM O-RING

D004078E01

7. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY

  1. D008129E02
    Using a caliper gauge, measure the inside diameter of the underdrive clutch drum bush.

    Standard drum bush:
    32.56 to 32.58 mm (1.2818 to 1.2826 in.)

    Maximum drum bush:
    32.63 mm (1.2846 in.)

    If the inside diameter is greater than the maximum, replace the underdrive clutch drum sub-assembly.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →