2005-2008 RAV4 · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT UNDERDRIVE PACK CLEARANCE
  1. Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. D008123E01
    Install a dial indicator as shown in the illustration.

  1. D008124E01
    Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    1.51 to 1.90 mm (0.0594 to 0.0748 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.


INSPECT NO. 1 UNDERDRIVE CLUTCH DISC

  1. D004077E01
    Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D009214E01
    Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    17.14 mm (0.6748 in.)


INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY

  1. D008129E02
    Using a caliper gauge, measure the inside diameter of the underdrive clutch drum bush.

    Standard drum bush:
    32.56 to 32.58 mm (1.2818 to 1.2826 in.)

    Maximum drum bush:
    32.63 mm (1.2846 in.)

    If the inside diameter is greater than the maximum, replace the underdrive clutch drum sub-assembly.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →