2005-2008 RAV4 · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL UNDERDRIVE CLUTCH DRUM O-RING

  1. D004078E01
    Coat a new O-ring with ATF and install it to the underdrive clutch drum.


2. INSTALL UNDERDRIVE CLUTCH PISTON SET

  1. D003860E01
    Coat the underdrive clutch piston with ATF, and install it to the underdrive clutch piston drum.

    NOTICE:
    Be careful not to damage the O-ring.

  1. D003704E01
    Install the piston return spring and clutch balancer to the underdrive clutch drum.

    NOTICE:
    Be careful not to damage the lip seal of the clutch balancer.

  1. D003703E02
    Place SST on the clutch balancer and compress the piston return spring with a press.
    SST
    09350-32014   (09351-32070)

  1. Using a snap ring expander, install the snap ring to underdrive clutch drum.

    NOTICE:
    1. Be sure the end gap of the snap ring is not aligned with the clutch balancer's claw.
    2. Stop the press when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the sap ring groove.
    3. This prevents the spring sheet from being deformed.
    4. Do not expand the snap ring excessively.


3. INSTALL NO. 1 UNDERDRIVE CLUTCH DISC

  1. C129394E01
    Install the 3 plates, 3 discs and flange.

    Install in order:
    P - D - P - D - P - D - F

    HINT:
    P = Plate
    D = Disc
    F = Flange

  1. D008125E01
    Using a screwdriver, install the snap ring.

  1. Check that the end gap of the snap ring is not aligned with one of the cutouts.


4. INSPECT UNDERDRIVE PACK CLEARANCE
  1. Install the underdrive clutch to the transaxle case.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. D008123E01
    Set a dial indicator as shown in the illustration.

  1. D008124E01
    Measure the underdrive clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    1.51 to 1.90 mm (0.0594 to 0.0748 in.)

    If the pack clearance is less than the minimum, parts may have been assembled incorrectly, so check and reassemble again.
    If the park clearance is not as specified, select another flange.

    HINT:
    There are 3 flanges in different thickness.

    Standard flange thickness:
    No.
    Thickness
    No.
    Thickness
    A
    3.0 mm (0.118 in.)
    C
    3.4 mm (0.134 in.)
    B
    3.2 mm (0.126 in.)
    -
    -

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →