2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FRONT EXHAUST PIPE ASSEMBLY

  1. A077857E03
    Using a vernier caliper, measure the free length of the compression spring.

    Minimum length:
    41.5 mm (1.634 in.)

    If the length is less than the minimum, replace the compression spring.

  1. A133205E01
    Install a new gasket by hand so that its surface is flush with the center exhaust manifold.

    NOTICE:
    1. Make sure the gasket is facing the correct direction.
    2. Do not reuse the removed gasket.
    3. Do not push in the gasket while installing the exhaust pipe.

  1. Connect the 3 exhaust pipe supports, and install the front exhaust pipe.

  1. Install the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


    A126833


2. INSTALL TAILPIPE ASSEMBLY

  1. A077857E03
    Using a vernier caliper, measure the free length of the compression spring.

    Minimum length:
    38.5 mm (1.516 in.)

    If the length is less than the minimum, replace the compression spring.

  1. A133205E01
    Install a new gasket by hand so that its surface is flush with the center exhaust pipe.

    NOTICE:
    1. Make sure the gasket is facing the correct direction.
    2. Do not reuse the removed gasket.
    3. Do not push in the gasket while installing the tailpipe.

  1. Connect the 2 exhaust pipe supports, and install the tailpipe.

  1. Install the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


    A126834


3. INSTALL AIR-FUEL RATIO SENSOR

  1. A126974E01
    Using SST, install the sensor to the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure SST and wrench are connected in a straight line.

  1. A126972
    Connect the sensor connector.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
← REMOVAL (from Nov 2005)COMPONENTS (from Nov 2005) →