2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2007


1. INSTALL FRONT EXHAUST PIPE ASSEMBLY

  1. A077857E03
    Using vernier calipers, measure the free length of the compression spring.
    Minimum length
    41.5 mm (1.634 in.)
    If the length is less than the minimum, replace the compression spring.

  1. A076194E04
    Using plastic hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold converter sub-assembly.

    NOTICE:
    1. Be careful with the installation direction of the gasket.
    2. Do not reuse the gasket.
    3. Do not damage the gasket.
    4. To ensure a proper seal, do not use the front exhaust pipe to force the gasket onto the exhaust manifold converter sub-assembly.

  1. Connect the 3 exhaust pipe supports, and install the front exhaust pipe.

  1. Install the 2 compression springs and 2 bolts.

    A126833

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


2. INSTALL TAILPIPE ASSEMBLY

  1. A077857E03
    Using vernier calipers, measure the free length of the compression spring.
    Minimum length
    38.5 mm (1.516 in.)
    If the length is less than the minimum, replace the compression spring.

  1. A076194E04
    Using plastic hammer and wooden block, tap in a new gasket until its surface is flush with the front exhaust pipe.

    NOTICE:
    1. Be careful with the installation direction of the gasket.
    2. Do not reuse the gasket.
    3. Do not damage the gasket.
    4. To ensure a proper seal, do not use the tailpipe to force the gasket onto the front exhaust pipe.

  1. Connect the 2 exhaust pipe supports, and install the tailpipe.

  1. Install the 2 compression springs and 2 bolts.

    A160483

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


3. INSTALL AIR-FUEL RATIO SENSOR

  1. A126974E01
    Using SST, install the sensor to the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and a wrench are connected in a straight line.

  1. A126972
    Connect the sensor connector.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. INSPECT FOR EXHAUST GAS LEAK
If exhaust gas is leaking, repair the leak. Replace damaged parts as necessary.
← REMOVAL (from Jan 2007)COMPONENTS (from Nov 2005) →