REMOVAL
Removal / installation · Vehicles built from Jan 2007
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE AIR-FUEL RATIO SENSOR |
Disconnect the sensor connector.

Using SST, remove the sensor from the front exhaust pipe.

- SST
- 09224-00010
| 3. REMOVE TAILPIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Disconnect the 2 exhaust pipe supports, and remove the tailpipe.
Remove the gasket from the front exhaust pipe.


| 4. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Disconnect the 3 exhaust pipe supports, and remove the front exhaust pipe.
Remove the gasket from the exhaust manifold converter sub-assembly.


