2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

  1. A097616E02
    Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel pressure regulator.

  1. A110141E01
    Install the fuel pressure regulator to the fuel filter.


2. INSTALL FUEL PUMP ASSEMBLY

  1. A126130
    Connect the fuel pump harness connector.

  1. A126641E01
    Apply gasoline to a new O-ring and install the O-ring to the filter.

  1. Attach the 5 claws to the claw holes and install the fuel pump.


3. INSTALL BRACKET

  1. A126889
    Attach the 2 claws to the claw holes and install the bracket.


4. INSTALL FUEL SUB-TANK ASSEMBLY

  1. A126125
    Attach the 2 claws to the claw holes and install the sub-tank.

  1. A126123
    Connect the wire harness.

  1. A126684
    Install the 2 springs to the fuel suction plate shafts and install it to the sub-tank.

  1. A126124E01
    Using needle nose pliers, install a new E-ring.

    HINT:
    Slightly lower the sub-tank to install the E-ring.


5. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY

  1. A126699E02
    Install a new gasket onto the fuel pump.

  1. A131634
    Connect the fuel hose and install the fuel pump into the fuel tank.

    NOTICE:
    Do not damage the fuel pump filter.


6. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


7. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124668
    Install the fuel tube with the joint clip.

    CAUTION:
    A124131E01
    1. Check that there are no scratches or foreign objects on the connecting parts.
    1. Check that the fuel tube joint is inserted securely.
    1. Check that the fuel tube joint clip is on the collars of the fuel tube joint.
    1. After installing the tube joint clip, check that the fuel tube joint has not been pulled off.
    1. Be careful not to damage the clip. If the clip is damaged, replace it.


8. CONNECT FUEL EMISSION HOSE

  1. A124674
    Install the purge line hose, air inlet line hose and EVAP line tube to the fuel pump.


9. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank (Click here).

← REMOVAL (from Aug 2008)INSTALLATION (from Aug 2008) →