2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2007 – Jul 2008

Versions by build date: Aug 2007 – Jul 2008 from Aug 2008


1. REMOVE FUEL TANK ASSEMBLY
  1. Remove the fuel tank (Click here).


2. DISCONNECT FUEL EMISSION HOSE

  1. A124674
    Remove the purge line hose, air inlet line hose and EVAP line tube from the fuel pump.


3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124669
    Remove the joint clip and fuel tank main tube.

    CAUTION:
    1. Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary.
    1. Keep the O-ring free of foreign matter, as it becomes contaminated easily.
    1. Do not use any tools in this procedure.
    1. Do not forcefully bend or twist the tube.
    1. Put the tube in a plastic bag to prevent damage and contamination.
    1. If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
    1. Be careful not to damage the clip. If the clip is damaged, replace it.


4. REMOVE FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Remove the 8 bolts and set plate.


5. REMOVE FUEL SUCTION WITH PUMP ASSEMBLY

  1. A124676
    Disconnect the fuel hose and remove the fuel suction with pump assembly from the fuel tank.

    NOTICE:
    1. Do not damage the wire harness.
    2. Do not separate the tube indicated in the illustration (Click here).

  1. A126699E02
    Remove the gasket from the fuel suction plate.


6. REMOVE NO. 1 FUEL SUB-TANK

  1. A126123
    Disconnect the wire harness.

  1. A126124E01
    Using needle nose pliers, remove the E-ring.

    HINT:
    Slightly lower the sub-tank to remove the E-ring.

  1. A126684
    Remove the 2 springs from the 2 shafts.

  1. A185514
    Detach the 2 claws and remove the sub-tank.


7. REMOVE BRACKET

  1. A185513
    Using a screwdriver, detach the 2 claws and remove the bracket.

    HINT:
    Tape the screwdriver tip before use.


8. REMOVE FUEL PUMP

  1. A126894E01
    Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.

    NOTICE:
    1. Do not damage the wire harness.
    2. Do not separate the tube indicated in the illustration (Click here).

  1. A126130
    Disconnect the fuel pump connector.

  1. A126641E02
    Remove the O-ring from the fuel filter.


9. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

  1. A110141E01
    Remove the pressure regulator from the fuel filter.

  1. Remove the 2 O-rings.

← COMPONENTS (from Aug 2008)REMOVAL (from Aug 2008) →