2005-2008 RAV4 · Service Manual BODY ELECTRICAL

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built from Nov 2005


DESCRIPTION
E124614E01
  1. Key reminder warning system data can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.


CHECK DLC3
The vehicle's ECM uses ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-03 and matches the ISO 15765-4 format.
H100769E16
Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
10 to 14 V
CANH (6) - CANL (14)
HIGH-level CAN bus line
Ignition switch off*
54 to 69 Ω
CANH (6) - Battery positive
HIGH-level CAN bus line
Ignition switch off*
1 MΩ or higher
CANL (6) - CG (4)
HIGH-level CAN bus line
Ignition switch off*
200 MΩ or higher
CANH (14) - Battery positive
LOW-level CAN bus line
Ignition switch off*
1 MΩ or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Ignition switch off*
200 MΩ or higher

NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, other switches or doors.

  1. If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

HINT:
Connect the cable of the intelligent tester to the DCL3, turn the ignition switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
  1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.
  2. If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.

← TERMINALS OF ECU (from Nov 2005)DATA LIST / ACTIVE TEST (from Nov 2005) →