2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE)
  1. Remove the air cleaner case (Click here).

    HINT:
    Refer to the procedures from the removal of the purge VSV up until the removal of the air cleaner case.


3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE)
  1. Remove the air cleaner case (Click here).

    HINT:
    Refer to the procedures from the removal of the purge VSV up until the removal of the air cleaner case.


4. REMOVE AIR CLEANER BRACKET (for 2AD-FTV)
  1. Remove the air cleaner bracket (Click here).

    HINT:
    Refer to the procedures from the removal of the air cleaner cap sub-assembly up until the removal of the air cleaner bracket.


5. REMOVE AIR CLEANER BRACKET (for 2AD-FHV)
  1. Remove the air cleaner bracket (Click here).

    HINT:
    Refer to the procedures from the removal of the air cleaner cap sub-assembly up until the removal of the air cleaner bracket.


6. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


7. DISCONNECT BRAKE LINES

  1. C129066
    Using SST, disconnect the 6 brake lines from the actuator.
    SST
    09023-00101  

  1. C129067E01
    Place tags or marks to identify the installation locations of each brake line.


8. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET

  1. C129068
    Release the latch of the actuator connector and disconnect the connector.

  1. C128743
    Disconnect the brake tube clamp from the bracket.

  1. C129069
    Remove the 3 nuts and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.

← REMOVAL (Jan 2007 – Jul 2007)DISASSEMBLY (from Nov 2005) →