REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 3.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH |
 |
for Short Body:
Remove the deck trim side panel LH (Click here).
- HINT:
- Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.
for Long Body:
Remove the deck trim side panel LH (Click here).
- HINT:
- Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.
| 4.
REMOVE REAR SPEED SENSOR LH |
 |
- Disconnect the speed sensor connector.
- Disconnect the grommet of the speed sensor wire from the hole of the wheel house.
- Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.
Remove the 2 nuts (labeled C) and sensor clamps (labeled D) from the upper arm.
- Remove the nut (labeled E) and sensor clamp (labeled F) from the trailing arm.
Remove the bolt (labeled G) and sensor body (labeled H) from the carrier.
- NOTICE:
- Keep the sensor tip and sensor installation hole free from foreign matter.