2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE REAR WHEEL

3. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
  1. for Short Body:
    Remove the deck trim side panel LH (Click here).

    HINT:
    Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.

  1. for Long Body:
    Remove the deck trim side panel LH (Click here).

    HINT:
    Refer to the procedures from the removal of the rear door scuff plate LH up until the removal of the deck trim side panel assembly LH.


4. REMOVE REAR SPEED SENSOR LH

  1. C127328
    Disconnect the speed sensor connector.

  1. C127970E01
    Disconnect the grommet of the speed sensor wire from the hole of the wheel house.

  1. C127973E01
    Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.

  1. Remove the 2 nuts (labeled C) and sensor clamps (labeled D) from the upper arm.

  1. C127972E01
    Remove the nut (labeled E) and sensor clamp (labeled F) from the trailing arm.

  1. Remove the bolt (labeled G) and sensor body (labeled H) from the carrier.

    NOTICE:
    Keep the sensor tip and sensor installation hole free from foreign matter.

← REMOVAL (Nov 2005 – Dec 2006)INSPECTION (from Nov 2005) →