Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006from Jan 2007
1.
PRECAUTION
CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
3.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
NOTICE:
When reconnecting the cable to the negative (-) battery terminal after installing the steering sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative (-) battery terminal.
4.
REMOVE STEERING PAD ASSEMBLY
Straighten the front wheels.
Using a T30 "torx" driver, loosen the 2 screws until the groove along each screw circumference catches on the screw case.
Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.
Using a screwdriver, disconnect the 2 airbag connectors.
CAUTION:
When handling the airbag connector, do not damage the airbag wire harness.
Disconnect the horn connector and remove the steering pad.
5.
REMOVE STEERING WHEEL ASSEMBLY (for LHD)
Remove the nut and place matchmarks on the steering wheel and steering column.