2005-2008 RAV4 · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. PRECAUTION

CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

NOTICE:
When reconnecting the cable to the negative (-) battery terminal after installing the steering sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative (-) battery terminal.


4. REMOVE STEERING PAD ASSEMBLY

B130245E01
  1. Straighten the front wheels.

  1. Using a T30 "torx" driver, loosen the 2 screws until the groove along each screw circumference catches on the screw case.

  1. B127893E01
    Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.


5. REMOVE STEERING WHEEL ASSEMBLY (for LHD)

  1. C132123E01
    Remove the nut and place matchmarks on the steering wheel and steering column.

  1. C132124E02
    Using SST, remove the steering wheel.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.


6. REMOVE STEERING WHEEL ASSEMBLY (for RHD)

  1. C132125E01
    Remove the nut and place matchmarks on the steering wheel and steering column.

  1. C132126E01
    Using SST, remove the steering wheel.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.


7. REMOVE STEERING COLUMN COVER (for LHD)

  1. C128491
    Detatch the 4 claws, release the tilt lever and remove the lower steering column cover.

  1. C128492
    Detach the claw and remove the upper steering column cover.


8. REMOVE STEERING COLUMN COVER (for RHD)

  1. C127464
    Detach the 4 claws, release the tilt lever and remove the steering column cover lower.

  1. C127465
    Detach the claw and remove the steering column cover upper.


9. REMOVE SPIRAL CABLE SUB-ASSEMBLY (for LHD)

  1. C128493
    Disconnect all connectors from the turn signal switch with spiral cable.


10. REMOVE SPIRAL CABLE SUB-ASSEMBLY (for RHD)

  1. C127466
    Disconnect all connectors from the turn signal switch with spiral cable.


11. REMOVE STEERING ANGLE SENSOR

  1. C128529
    Detach the 6 claws and remove the sensor from the spiral cable.

← REMOVAL (Nov 2005 – Dec 2006)INSPECTION (from Nov 2005) →