REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
REMOVE REAR DOOR SCUFF PLATE RH |
 |
Using a screwdriver, detach the 8 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
| 2.
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
|
| 3.
REMOVE REAR FLOOR NO. 1 BOARD |
|
| 4.
REMOVE DECK BOARD ASSEMBLY |
|
| 5.
REMOVE REAR FLOOR NO. 3 BOARD |
|
| 6.
REMOVE REAR FLOOR NO. 2 BOARD |
|
| 7.
REMOVE JACK CARRIER ASSEMBLY
|
 |
Using a clip remover, remove the 7 clips and remove the jack carrier.
| 8.
REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE
|
 |
Remove the 4 screws.
Using a clip remover, detach the 7 clips and remove the plate.
| 9.
REMOVE REAR FLOOR FINISH PLATE
|
 |
- Using a clip remover, detach the 6 clips and remove the finish plate.
| 10.
REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH
|
 |
- Using a screwdriver, detach the 6 claws and remove the bezel.
- HINT:
- Tape the screwdriver tip before use.
| 11.
REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER
|
 |
- Using a screwdriver, detach the 6 claws and remove the bezel.
- HINT:
- Tape the screwdriver tip before use.
| 12.
REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
|
 |
- Remove the bolt, 2 washers, collar and bracket.
| 13.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
|
 |
- Disconnect the rear No. 1 seat belt's floor anchor.
Remove the anchor cover.
Remove the bolt and disconnect the floor anchor.
- Remove the bolt and 2 screws.
Using a screwdriver, detach the 5 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 5 clips and remove the trim board.
Remove the belt hanger.
| 14.
REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH |
 |
Using a clip remover, detach the 7 clips and remove the garnish.
| 15.
REMOVE DOOR CONTROL RECEIVER |
 |
Disconnect the receiver connector.
Remove the bolt and receiver.