2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. REMOVE REAR DOOR SCUFF PLATE RH

B132554
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.


2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

3. REMOVE REAR FLOOR NO. 1 BOARD

4. REMOVE DECK BOARD ASSEMBLY

5. REMOVE REAR FLOOR NO. 3 BOARD

6. REMOVE REAR FLOOR NO. 2 BOARD

7. REMOVE JACK CARRIER ASSEMBLY

B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.


8. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE

B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.


9. REMOVE REAR FLOOR FINISH PLATE

  1. B129716
    Using a clip remover, detach the 6 clips and remove the finish plate.


10. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH

  1. B135482
    Using a screwdriver, detach the 6 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.


11. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER

B131613
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


12. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET

  1. B130163
    Remove the bolt, 2 washers, collar and bracket.


13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

  1. B137547
    Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.

  1. B129713
    Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Remove the belt hanger.


14. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH

B132555
  1. Using a clip remover, detach the 7 clips and remove the garnish.


15. REMOVE DOOR CONTROL RECEIVER

B132556
  1. Disconnect the receiver connector.

  1. Remove the bolt and receiver.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →