Key Lock-in Prevention Function does not Work Properly
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
When the key is in the ignition key cylinder or the door courtesy light ON signal is output to the main body ECU, performing the door lock operation with the lock switch does not lock the door.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH) |
Use the Data List to check if the unlock warning switch is functioning properly.
Main body ECU Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
Key Unlock Warning SW
Unlock warning switch signal / ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-
- OK:
- When the switch is operating, the intelligent tester should display as shown in the table.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (DRIVER SIDE DOOR COURTESY LIGHT SWITCH) |
Use the Data List to check if the door courtesy light switch is functioning properly.
Main body ECU Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
D Door Courtesy SW
Driver side door courtesy light switch signal / ON or OFF
ON: Driver side door is open
OFF: Driver side door is closed
-
- OK:
- When the switch is operating, the intelligent tester should display as shown in the table.
|
|
||||
| NG | |
| 3. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH |
Remove the front door courtesy light switch.

Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - Body ground
Not pushed (ON)
Below 1 Ω
1 - Body ground
Pushed (OFF)
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (SWITCH - ECU) |


for LHD:
Disconnect the K8 switch connector.
Disconnect the IA junction block connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
K8-1 - IA-21 (DCTY)
Below 1 Ω
for RHD:
Disconnect the L4 switch connector.
Disconnect the IC junction block connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
L4-1 - IC-6 (DCTY)
Below 1 Ω
|
|
||||
| OK | ||
| ||
| 5. INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Remove the unlock warning switch.

Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1- 2
Not pushed
10 kΩ or higher
1- 2
Pushed
Below 1 Ω
|
|
||||
| OK | |
| 6. CHECK WIRE HARNESS (SWITCH - ECU) |
Disconnect the E9 switch connector.

Disconnect the IE junction block connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E9-1 - Body ground
Below 1 Ω
E9-1 - IE26 (KSW)
Below 1 Ω
|
|
||||
| OK | ||
| ||
