2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Only Back Door LOCK / UNLOCK Functions do not Operate

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The main body ECU receives lock / unlock switch signals and activates the door lock motor accordingly.

WIRING DIAGRAM

E114761E06

INSPECTION PROCEDURE


1. INSPECT BACK DOOR WITH MOTOR LOCK ASSEMBLY

  1. E123892E03
    Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 4 (ACT+)
    Battery negative (-) → 1 (ACT-)
    Lock
    Battery positive (+) → 1 (ACT-)
    Battery negative (-) → 4 (ACT+)
    Unlock

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (S) - 8 (E)
    Lock
    10 kΩ or higher
    7 (S) - 8 (E)
    Unlock
    Below 1 Ω



NG
REPLACE BACK DOOR WITH MOTOR LOCK ASSEMBLY
OK


2. CHECK WIRE HARNESS (ECU - DOOR LOCK)
E123902E07
  1. w/ Double Locking System:

    1. Disconnect the S10 door lock connector.

    2. Disconnect the IH junction block connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      S10-1 (ACT-) - IH-18 (ACT-)
      Below 1 Ω
      S10-4 (ACT+) - IH-17 (ACT+)
      Below 1 Ω
      S10-7 (S) - E18-10 (LSWP)
      Below 1 Ω
      S10-8 (E) - Body ground
      Below 1 Ω

  1. w/o Double Locking System:

    1. Disconnect the S10 door lock connector.

    2. Disconnect the E18 ECU connector.

    3. Disconnect the IH junction block connector.

    4. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      S10-1 (ACT-) - IH-18 (ACT-)
      Below 1 Ω
      S10-4 (ACT+) - IH-17 (ACT+)
      Below 1 Ω
      S10-7 (S) - E18-13 (LSWB)
      Below 1 Ω
      S10-8 (E) - Body ground
      Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)


← Only Rear Door RH LOCK / UNLOCK Functions do not Operate (from Nov 2005)Key Lock-in Prevention Function does not Work Properly (from Nov 2005) →