Only Rear Door RH LOCK / UNLOCK Functions do not Operate
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The main body ECU receives lock / unlock switch signals and activates the door lock motor accordingly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT REAR DOOR WITH MOTOR LOCK ASSEMBLY RH |
for LHD, RHD (w/o Double Locking System):

Apply the battery voltage to the door lock motor and check the operation of the door lock motor.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL)
Lock
Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L)
Unlock
for RHD (w/ Double Locking System):

Apply the battery voltage to the door lock motor and check the operation of the door lock motor.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → 4 (L)
Battery negative (-) → 3 (UL)
Lock
Battery positive (+) → 3 (UL)
Battery negative (-) → 4 (L)
Unlock
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (DOOR LOCK - ECU) |


Disconnect the I4 door lock connector.
Disconnect the IH junction block connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
- for LHD, RHD (w/o Double Locking System):
Tester Connection
Specified Condition
I4-1 (UL) - IH-18 (ACT-)
Below 1 Ω
I4-4 (L) - IH-17 (ACT+)
Below 1 Ω
- for RHD (w/ Double Locking System):
Tester Connection
Specified Condition
I4-3 (UL) - IH-18 (ACT-)
Below 1 Ω
I4-4 (L) - IH-17 (ACT+)
Below 1 Ω
|
|
||||
| OK | ||
| ||
