2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT BACK DOOR WITH MOTOR LOCK ASSEMBLY

  1. E123892E03
    Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 4 (ACT+)
    Battery negative (-) → 1 (ACT-)
    Lock
    Battery positive (+) → 1 (ACT-)
    Battery negative (-) → 4 (ACT+)
    Unlock

    1. If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (S) - 8 (E)
    Lock
    10 kΩ or higher
    7 (S) - 8 (E)
    Unlock
    Below 1 Ω

    1. If the result is not as specified, replace the door lock assembly.

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →