2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

  1. C128869
    Install the ECU with the bolt.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }

  1. Connect the connector.


2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)

B129887
  1. Attach the 2 hinges to install the door.

  1. B129889E03
    Attach the claw to the glove compartment door stopper.

  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.


3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER (for RHD)
  1. Attach the 8 claws to install the lower instrument panel finish panel.

  1. Install the 2 screws.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

5. REGISTER TRANSMITTER ID

NOTICE:
It is necessary to register the transmitter ID in the tire pressure warning ECU and receiver when replacing the tire wheel and/or tire pressure warning ECU and receiver.

  1. Prepare all of the transmitter ID data before starting registration.

    HINT:
    1. Read the registered transmitter IDs that are stored in the ECU using the intelligent tester and make a note of them.
    2. If reading stored transmitter IDs is impossible due to malfunctions of components such as the tire pressure warning antenna and receiver, replace the tire wheel.
    3. When replacing the tire wheel, wriee down the IDs from the sticker on the inside surface of the tire wheel.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. F101089
    *1: Read and write down the ID (ID1 to ID4) by using the Data List.

  1. F101090
    *2: Select REGIST TIRE SET following the intelligent tester screen (UTILITY - REGIST TIRE SET).

  1. *3: Select the registration mode "MAIN".

  1. F101091
    Input the ID (ID1 to ID4) using the intelligent tester and transmit it to the tire pressure warning ECU and receiver.

  1. Set the ID transmission condition to "ID Registration is complete".

    F101092E01

    HINT:
    1. The previously registered IDs will be deleted from the memory when the registration is completed.
    2. If the operations of *1 to *3 are not completed within 5 minutes, the mode will return to normal operation mode.


6. INSPECT TIRE PRESSURE WARNING SYSTEM
← REMOVAL (from Jan 2007)INSTALLATION (Jan 2007 – Jul 2007) →