REMOVAL
Removal / installation · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD) |
![]() ![]() |
Open the glove compartment door.
Detach the claw from the glove compartment door stopper.
While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, open the door to release it from the 2 stoppers.
Open the door until it is horizontal.

Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.

| 3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (for RHD) |
Remove the 2 screws.
Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.
| 4. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER |
Disconnect the connector.
Remove the bolt and ECU.


