2005-2008 RAV4 · Service Manual BODY

B1273 Sliding Roof ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

DTC B1273 is output when the communication between the sliding roof drive gear and main body ECU stops for more than 10 seconds.

HINT:
w/ Entry and start system

NOTICE:
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.

DTC No.
DTC Detection Condition
Trouble Area
B1273
No communication from sliding roof drive gear for more than 10 seconds
1. Sliding roof drive gear
2. Main body ECU
3. Wire harness

WIRING DIAGRAM

B130916E01

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    DTC No.
    Proceed to
    DTC B1273 is output
    A
    DTC B1273 is not output
    B



B
SYSTEM IS OK
A


2. READ VALUE USING INTELLIGENT TESTER (COMMUNICATION SLIDING ROOF DRIVE GEAR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Read the DATA LIST according to the display on the tester.

    Main body ECU 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Communication Slide Roof
    Connection status between sliding roof drive gear sub-assembly (sliding roof control ECU) and main body ECU / OK or STOP
    OK: Connection
    STOP: No connection
    -



OK
REPLACE INSTRUMENT PANEL JUNCTION BLOCK
NG


3. CHECK WIRE HARNESS (MAIN BODY ECU - SLIDING ROOF DRIVE GEAR)

  1. B130934E03
    Disconnect the R9 gear connector.

  1. Disconnect the E18 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R9-4 (MPX1) - E18-15 (LIN2)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK FOR DTC
  1. Turn the ignition switch on (IG).

  1. Clear the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC B1273 is not output.



NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK


← ON-VEHICLE INSPECTION (from Nov 2005)B2325 LIN Communication Bus Malfunction (from Nov 2005) →