2005-2008 RAV4 · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Aug 2008

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (SKID CONTROL SENSOR)
  1. Install the rear axle hub and bearing LH (Click here).


2. INSTALL REAR DISC

  1. C127291E01
    Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.


3. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH

  1. C127287
    Install the cylinder mounting with the 2 bolts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }


4. INSTALL SKID CONTROL SENSOR WIRE

NOTICE:
To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.

  1. C127966E02
    Connect the skid control sensor wire connector (labeled A) to the skid control sensor.

  1. Install the sensor clamp (labeled B) with the bolt (labeled C).

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the clamp.

  1. C127967E02
    Install the sensor clamps (labeled D) with the 2 nuts (labeled E).

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the clamps.

  1. Install the sensor clamp (labeled F) with the bolt (labeled G).

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the clamp.

  1. C127968E01
    Insert the connector and grommet into the inside of the vehicle through the passage hole in the wheel house.

    NOTICE:
    Make sure the grommet's band clamp remains on the outside of the vehicle.

  1. C127969E01
    Hold the grommet and pull it toward the outside of the vehicle. Then fix the grommet in place so that it is not tilted.

    NOTICE:
    1. When pulling out the grommet, do not grip the sensor wire.
    2. Fix the grommet in place within the range shown in the illustration.

  1. C127328
    Connect the skid control sensor wire connector.


5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
  1. Install the deck trim side panel LH (Click here).

    HINT:
    Refer to the procedures from the installation of the deck trim side panel LH up until the installation of the rear door scuff plate LH.


6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. CHECK SPEED SENSOR SIGNAL
  1. w/o VSC:
    Check the speed sensor signal (Click here).

  1. w/ VSC:
    Check the speed sensor signal (Click here).

← INSTALLATION (Aug 2007 – Jul 2008)COMPONENTS (from Nov 2005) →