ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| INSPECT BRAKE PEDAL LOAD SENSING SWITCH |
- HINT:
- Do not remove the brake pedal load sensing switch from the brake pedal support.
- When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support.
- Do not remove the brake pedal load sensing switch from the brake pedal support.
Disconnect the brake pedal load sensing switch connector.




Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Brake pedal depressed
Approx. 1 kΩ
1 - 2
Brake pedal released
Approx. 213 Ω
