2005-2008 RAV4 · Service Manual COMMUNICATION SYSTEM

B1207 Certification ECU Communication Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

Detection Item
Symptom
Trouble Area
CERTIFICATION ECU COMMUNICATION STOP MODE
  1. Entry & Start is not displayed on "BUS CHECK" screen of intelligent tester.
  2. Applies to "CERTIFICATION ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE".
  1. Power source circuit of certification ECU
  2. Certification ECU branch wire and connector
  3. Certification ECU

HINT:
For vehicle with entry and start system only.


WIRING DIAGRAM

C129192E10

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Clear the DTC.

  1. Check for DTC.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO ENTRY AND START SYSTEM
A


2. CHECK CAN BUS LINE FOR DISCONNECTION (CERTIFICATION ECU BRANCH WIRE)

  1. C128518E01
    Disconnect the E63 certification ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E63-27 (CANH) - E63-28 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO CERTIFICATION ECU (CANH, CANL)
OK


3. CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY AND BODY GROUND)

  1. C128518E02
    Disconnect the E63 certification ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E63-17 (E) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E63-1 (+B1) - Body ground
    Always
    10 to 14 V
    E63-18 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CERTIFICATION ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Nov 2005)B2326 CAN MS Bus Line Communication Malfunction (from Nov 2005) →