INSTALLATION
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
| 1.
INSTALL TRANSAXLE CONTROL CABLE ASSEMBLY |
 |
Install the control cable with the 2 bolts.
-
Torque:
- 5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
- Connect the control cable to the control cable bracket, and install 2 new clips.
Connect the control cable to the transaxle, and install the 2 washers and 2 clips.
| 2.
CONNECT TRANSAXLE CONTROL CABLE ASSEMBLY |
 |
Connect the ends of the control cable and install the 2 clips to the shift lever.
Turn the lock nuts of the shift cable 270° counterclockwise, and hold them in that position.
Install the shift cable while holding them.
Check that the cables are installed securely.
- Push in the cable locks of the shift cable and select cable.
- Connect the cable ends of the control cable and install the 2 clips.
| 3.
INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
|
 |
Connect the connector.
Install the rear console box with the 2 bolts and 2 screws.
Install the console box carpet.
| 4.
INSTALL CONSOLE REAR END PANEL
|
 |
Attach the 6 claws to install the console rear end panel.
| 5.
INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
|
 |
Connect the connector.
Attach the 4 clips to install the upper rear console panel.
| 6.
INSTALL CONSOLE CUP HOLDER BOX
|
 |
Attach the 2 clips to install the cup holder box.
Install the 2 screws.
| 7.
INSTALL SWITCH BASE
|
 |
Connect the connectors.
Attach the 2 clips and 2 claws to install the switch base.
| 8.
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
Automatic transaxle:
Connect the connector.
Attach the 2 clips and 4 claws to install the upper console panel.
Install the shift lever knob.
| 9.
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
|
| 10.
INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH
|
 |
Attach the 4 clips to install the upper panel garnish.
| 11.
INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH
|
 |
Attach the 4 clips to install the upper panel garnish.
| 12.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|