2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH

B139541
  1. Using a screwdriver, detach the 4 clips and upper panel garnish.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH

B139542
  1. Using a screwdriver, detach the 4 clips and upper panel garnish.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

B129883
  1. Remove the shift lever knob.

  1. for Manual Transaxle:
    Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel.

    HINT:
    Tape the screwdriver tip before use.

  1. for Automatic Transaxle:
    Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel then disconnect the connector.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE SWITCH BASE

B129882
  1. Detach the 2 clips and 2 claws.

  1. Disconnect the connectors and remove the switch base.


7. REMOVE CONSOLE CUP HOLDER BOX

B129881
  1. Remove the 2 screws.

  1. Detach the 2 clips and remove the cup holder box.


8. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

B129880
  1. Using a screwdriver, detach the 4 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector and remove the upper rear console panel.


9. REMOVE CONSOLE REAR END PANEL

B129879
  1. Using a screwdriver, detach the 6 claws and remove the console rear end panel.

    HINT:
    Tape the screwdriver tip before use.


10. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

B129878
  1. Remove the console box carpet.

  1. Remove the 2 bolts and 2 screws.

  1. Disconnect the connector and remove the rear console box.


11. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY

C133965
  1. Remove the 2 clips and disconnect the cable ends of the control cable.

  1. C133960E01
    Using a screwdriver, release the cable locks of the shift cable and select cable.

  1. C133961E01
    Turn the lock nuts 180° counterclockwise and hold them in that position. Remove the shift cable and select cable while holding them.

  1. Remove the shift cable from the floor shift shift lever assembly while holding the lock nut.

  1. Repeat the step above for the select cable.

    NOTICE:
    Do not push in the cable locks.


12. REMOVE TRANSAXLE CONTROL CABLE ASSEMBLY

C127238E02
  1. Removal the 2 clips and washers, and disconnect the top ends of the control cable from the transaxle.

  1. Remove the 2 clips and disconnect the control cable bracket.

  1. C127242
    Remove the 2 bolts from the retainer.

  1. Pull out the control cable from the floor.

← REMOVAL (Nov 2005 – Dec 2006)ADJUSTMENT (from Nov 2005) →