SYSTEM DESCRIPTION
Troubleshooting · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 Aug 2007 – Jul 2008 from Aug 2008
| METER GAUGE AND WARNING / INDICATOR |
*2: w/o VSC
*1: except Europe
*2: for Europe
*3: for 4WD
*4: for 2WD w/ VSC
*5: w/ VSC
*6: w/o VSC
*7: for Diesel Engine
*1: w/ Entry and Start System
*2: w/o Entry and Start System
*3: for Europe
*4: for G.C.C.
| Item |
Detail |
| Speedometer |
Based on signals received from wheel speed sensor, ABS and traction actuator*1 (skid control ECU) or brake actuator*2 (skid control ECU) calculates vehicle speed and transmits data to meter (CAN line) |
| Tachometer |
ECM transmits engine speed to meter (CAN line) |
| Water Temperature Gauge |
ECM transmits water temperature signal to meter (CAN line) |
| Fuel Gauge |
Fuel sender gauge transmits signal to meter (Direct line) |
| Item |
Detail |
| TURN SIGNAL |
Receives turn signal from flasher relay (Direct line) |
| HAZARD SIGNAL |
Receives hazard warning signal from flasher relay (Direct line) |
| BEAM |
Receives high beam signal from main body ECU (CAN line) |
| FOG LIGHT |
Receives fog light signal from main body ECU (CAN line) |
| REAR FOG LIGHT |
Receives fog light signal from main body ECU (CAN line) |
| CHARGE |
Receives malfunction charge signal from ECM (CAN line and direct line) |
| CHECK E/G |
Receives malfunction check signal from ECM (Direct line) |
| DOOR*1 |
Open door indicator illuminates when receiving signal from main body ECU (CAN line) |
| D BELT |
Receives driver seat belt signal (unfastened) from center airbag sensor assembly (CAN line) |
| BRAKE |
|
| CRUISE |
Receives malfunction signal from ECM (CAN line) |
| AIR BAG |
Receives malfunction signal from center airbag sensor (CAN line) |
| SLIP |
|
| ABS |
Receives malfunction signal from ABS and traction actuator*5 (skid control ECU) or brake actuator*6 (skid control ECU) (CAN line) |
| MASTER WARNING*2 |
Receives malfunction ABS and traction actuator*5 (skid control ECU) or brake actuator*6 (skid control ECU) (CAN line) |
| TAIL |
Receives headlight dimmer switch condition signal from main body ECU (CAN line) |
| P/S |
Receives malfunction signal from power steering ECU (CAN line) |
| TIRE PRESSURE*1 |
Receives malfunction signal from tire pressure warning ECU (Direct line) |
| Downhill Assist Control |
Receives set / reset signal from ABS and traction actuator*5 (skid control ECU) or brake actuator*6 (skid control ECU) (CAN line) |
| ENGINE OIL*1 |
Receives warning signal from engine oil pressure switch (Direct line) |
| DIF. LOCK*3 |
Receives lock / unlock signal from 4WD control ECU (CAN line) |
| AUTO LSD*4 |
Receives ON / OFF signal from ABS and traction actuator*5 (skid control ECU) or brake actuator*6 (skid control ECU) (CAN line) |
| 4WD*2, 3 |
Receives ON / OFF signal from 4WD control ECU (CAN line) |
| A/T OIL TEMP*1 |
Receives warning signal from ECM (CAN line) |
| FUEL |
Receives remaining fuel signal from fuel sender gauge (Direct line) |
| GLOW*7 |
Receives engine preheating signal from ECM (CAN line) |
| TRC OFF*3, *5 |
Receives signal from ABS and traction actuator*5 (skid control ECU) or brake actuator*6 (skid control ECU) (CAN line) |
| VSC OFF*5 |
Receives signal from ABS and traction actuator*5 (skid control ECU) or brake actuator*6 (skid control ECU) (CAN line) |
| Item |
Detail |
| D BELT (Seat belt buzzer) |
Sounds when vehicle speed is 20 km/h (12.4 mph) or more and driver seat belt is unfastened |
| D BELT (Seat belt warning) |
Sounds when ignition switch is on (IG) and driver seat belt is unfastened |
| AUTO LSD |
Sounds when solenoid motor temperature is high |
| KEY REM*2 |
Sounds if key is in ignition key cylinder and door is opened with ignition switch off |
| Hill-start assist control (Set) |
Sounds once when hill-start assist control is set |
| Hill-start assist control (Reset) |
Sounds twice when hill-start assist control is canceled |
| ENTRY AND START (Once)*1 |
|
| ENTRY AND START (Continuous)*1 |
Sounds when "SHIFT TO P RANGE" is displayed on multi-information display (A/T only) |
| ENTRY AND START (Intermittent)*1 |
Sounds if key is inside vehicle and door is opened with ignition switch off |
| LIGHT REM*3 |
Sounds if headlight dimmer switch is ON when ignition switch is turned off |
| Speed Warning*4 |
Sounds at vehicle speeds of 113 km/h (70.2 mph) or more |
| Parking brake drag (Intermittent) |
Sounds when vehicle speed is 5 km/h (3.1 mph) or more and parking brake switch is on |
| Item (Display) |
Detail |
| CHECK BRAKE SYSTEM |
Brake system malfunction is detected. |
| CHECK ABS SYSTEM |
Anti-lock brake system malfunction is detected. |
| CHECK AIRBAG SYSTEM |
SRS airbag system malfunction is detected. |
| LOW ENGINE OIL PRESSURE |
Engine oil pressure is low. |
| CHECK ENGINE SYSTEM |
Engine electrical system malfunction is detected. |
| CHECK 4WD SYSTEM |
Four-wheel drive system malfunction is detected. |
| HIGH TRANSFER CASE OIL TEMP |
|
| 2WD |
Active torque control 4WD system is canceled. |
| CHARGE |
Charging system malfunction is detected. |
| DOOR OPEN |
Side doors and/or back door is opened. |
| LOW ENGINE OIL LEVEL |
Engine oil level is low. |
| HIGH WATER LEVEL |
Water in fuel filter has reached the specified level. |
| HIGH TRANSMISSION OIL TEMP |
Automatic transmission fluid temperature is too high. |
| ICE WARNING |
Road surface may be frozen. |
| SHIFT TO P RANGE |
Shift selector lever is not set "P" position. |
| PRESS THE BRAKE PEDAL |
Brake pedal is not depressed when starting engine. |
| PRESS THE CLUTCH PEDAL |
Clutch pedal is not depressed when starting engine. |
| NO KEY DETECTED |
|
| LOW FUEL |
Fuel in tank is nearly empty. |
| OIL MAINTENANCE REQUIRED SOON |
Oil change is nearly due. |
| OIL MAINTENANCE REQUIRED NOW |
Oil change is due. |
| LOW KEY BATTERY |
Electronic key battery is low. |
| CHECK STEERING LOCK |
Steering lock system malfunction is detected. |
| STEERING STILL LOCK |
Steering lock is stuck. |
| OIL MAINTENANCE RESET |
Engine oil replacement reminder is not reset. |
| MULTI-INFORMATION DISPLAY (Europe) |


- Current fuel consumption and average fuel consumption; possible driving range; average speed; language / unit setting display
- HINT:
- For information about changing between displays or changing display settings, refer to the owner's manual.
- Outside temperature display
- HINT:
- For information about changing between displays, refer to the owner's manual.
- ODO/TRIP display
- HINT:
- For information about changing between displays, refer to the owner's manual.
- Warning message display
- HINT:
- If a warning message is displayed, refer to the problem symptoms table (Click here).
- Test mode, Active Test display
Refer to each system for information on the test mode and Active Test.- HINT:
- The test mode and Active Test display are for the 4WD control system and VSC system.
- DTC display
If a DTC is displayed, refer to the relevant system for each code.- HINT:
- The meter displays DTCs of the ABS (display: ABS), VSC system (display: VSC), SRS (display: AIRBAG), 4WD control system (display: 4WD), power steering system (display: P/S) and cruise control system (display: CRUISE).
| LIQUID CRYSTAL DISPLAY (LCD) (except Europe) |


- Outside temperature display
- ODO/TRIP display
- Shift position display (A/T)