HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Nov 2005
- HINT:
- Use these procedures to troubleshoot the meter / gauge system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the meter / gauge system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM (CAN)* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result |
Proceed to |
| CAN DTC is not output |
A |
| CAN DTC is output |
B |
|
|||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
On-vehicle Inspection (Click here)
| |||||
| 6.REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
| |||||