2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Radio and Navigation Assembly Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The circuit provides power to the radio and navigation assembly.

WIRING DIAGRAM

I101984E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ACC, RAD NO. 1)
  1. Disconnect the ACC fuse from the instrument panel junction block.

  1. Disconnect the RAD NO. 1 from the No. 2 relay block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK WIRE HARNESS (RADIO AND NAVIGATION ASSEMBLY - BATTERY AND BODY GROUND)

  1. E106746E08
    Disconnect the E52 radio connector.

  1. Measure the voltage and resistance of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E52-4 (B) - Body ground
    Always
    10 to 14 V
    E52-3 (ACC) - Body ground
    Ignition switch on (ACC)
    10 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    E52-7 (GND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Microphone Circuit between Overhead J/B and Multi-display (from Nov 2005)COMPONENTS (from Nov 2005) →