2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Microphone Circuit between Overhead J/B and Multi-display

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit sends a microphone signal from the microphone to the radio and navigation assembly.
It also supplies power from the radio and navigation assembly to the microphone.

WIRING DIAGRAM

I102034E03

INSPECTION PROCEDURE


1. CHECK RADIO AND NAVIGATION ASSEMBLY

  1. I102033E02
    Measure the voltage of the radio.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E54-17 (MACC) - Body ground
    Ignition switch on (ACC)
    10 to 14 V



NG
REPLACE RADIO AND NAVIGATION ASSEMBLY
OK


2. CHECK WIRE HARNESS (RADIO AND NAVIGATION ASSEMBLY - OVERHEAD JUNCTION BLOCK)

  1. I102035E02
    Disconnect the E54 radio connector.

  1. Disconnect the R8 junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E54-17 (MACC) - R8-12 (ACC)
    Below 1 Ω
    E54-19 (MIC+) - R8-11 (MI1+)
    Below 1 Ω
    E54-20 (MIC-) - R8-10 (MIC-)
    Below 1 Ω
    E54-12 (TSW-) - E54-18 (SGND)
    Below 1 Ω
    E54-17 (MACC) - Body ground
    10 kΩ or higher
    E54-19 (MIC+) - Body ground
    10 kΩ or higher
    E54-20 (MIC-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Speed Signal Circuit (from Nov 2005)Radio and Navigation Assembly Power Source Circuit (from Nov 2005) →