2005-2008 RAV4 · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


CHECK PARKING BRAKE SWITCH ASSEMBLY
  1. Remove the rear console box (Click here).

    HINT:
    Refer to the procedures from the removal of the No. 1 console upper panel garnish up until the removal of the rear console box sub-assembly.

  1. Disconnect the parking brake switch connector.

  1. C118703E02
    Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Parking brake switch ON (Switch pin released)
    Below 1 Ω
    1 - Body ground
    Parking brake switch OFF (Switch pin pushed in)
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.

← ON-VEHICLE INSPECTION (Nov 2005 – Dec 2006)REMOVAL (Nov 2005 – Dec 2006) →