SYSTEM DESCRIPTION
Troubleshooting · Vehicles built from Nov 2005
- HINT:
- The rear view monitor system does not operate with the back door open. In such a case, a notice is displayed to inform the driver.
| GENERAL |
To assist the driver with parking the vehicle by displaying an image of the area behind the vehicle, this system has a television camera mounted on the back door. The system displays the image on the radio and navigation assembly.
This system consists of the following components:
Radio and navigation assembly
Television camera
This system is equipped with a self-diagnosis system, which is operated on a designated window that appears on the display panel, just as in the navigation system.
| FUNCTION OF COMPONENTS |
The radio and navigation assembly controls the system by using information from the following components:
Item
Function
Television Camera Assembly
- Mounted on the back door to transmit an image of the area behind the vehicle to the radio and navigation assembly.
- A color video camera that uses a CCD (Charge Coupled Device) and a wide-angle lens.
Radio and Navigation Assembly
- Receives video signals, which contain an image of the area behind the vehicle taken with the television camera assembly.
- Radio and navigation assembly effects control of the system by receiving the shift position signal from the park / neutral position switch*1 or back-up light switch*2.
- Displays the rear view monitor image on the display panel.
Park/Neutral Position Switch*1
Back-up Light Switch*2
Transmits a reverse shift position signal to the radio and navigation assembly.
Back Door Courtesy Light Switch
Transmits a door open signal to the radio and navigation assembly.
- HINT:
- *1: for Automatic Transaxle
- *2: for Manual Transaxle
- Mounted on the back door to transmit an image of the area behind the vehicle to the radio and navigation assembly.
| OPERATION EXPLANATION |
The park / neutral position switch (for automatic transaxle) or back-up light switch (for manual transaxle) sends an R position signal to the radio and navigation assembly when the shift lever is moved to the R position. After receiving the R position signal, the radio and navigation assembly switches from the navigation system to the rear view monitor system.
| NOTES FOR REAR VIEW MONITOR |
Notes for the rear view monitor.
The rear view monitor may not function properly if subjected to a severe impact by any hard object.
Do not "scrub" the lens of the camera because it is made of resin. Scrubbing it may scratch the cover and affect the image. Prevent organic solvents, waxes, bond removing solvents, or glass coating from adhering to the cover. If anything adheres to the cover, clean it off immediately and wash the lens with water.
Exposing the camera to a sudden temperature change may affect proper functioning of the camera.
A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.
Images are difficult to discern even in normal conditions if:
The camera lens is frosted over (the image immediately after turning the ignition switch on (IG) may be blurred or darker than normal).
A strong beam of light, such as a sunbeam or headlight, hits the camera.
It is too dark around the camera (at night, etc.).
The ambient temperature around the camera is either too high or too low.
- HINT:
- When a strong light, such as a sunbeam reflected off the vehicle's body, hits the camera, the image may be blurred. This is called the "SMEAR" phenomenon, peculiar to the CCD camera.