HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Nov 2005
- HINT:
- Use theses procedures to troubleshoot the rear view monitor system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK BACK DOOR |
Check that the back door is fully closed.
Check that the camera lens is not dirty with mud, foreign matter, etc.
| |||||
| 4.BASIC INSPECTION |
Turn the ignition switch on (ACC).
Check whether or not the display appears on the radio and navigation assembly.
ResultĀ Result
Proceed to
Display appears
A
Display does not appear
B
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||