2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Display Signal Circuit between Radio and Navigation Assembly and Television Camera Assembly

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This is the display signal circuit of the television camera assembly.

WIRING DIAGRAM

I102047E01

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (RADIO AND NAVIGATION ASSEMBLY - TELEVISION CAMERA)

  1. I102048E01
    Disconnect the E54 radio connector.

  1. Disconnect the S7 camera connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E54-24 (CA+) - S7-4 (CB+)
    Below 1 Ω
    E54-21 (CGND) - S7-3 (CGND)
    Below 1 Ω
    E54-22 (V+) - S7-2 (CV+)
    Below 1 Ω
    E54-23 (V-) - S7-1 (CV-)
    Below 1 Ω
    E54-24 (CA+) - Body ground
    10 kΩ or higher
    E54-21 (CGND) - Body ground
    10 kΩ or higher
    E54-22 (V+) - Body ground
    10 kΩ or higher
    E54-23 (V-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK TELEVISION CAMERA ASSEMBLY
I102049E01
  1. Reconnect the E54 radio connector.

  1. Reconnect the S7 camera connector.

  1. E119731E02
    Check the waveform of the camera using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Symbols (Terminal No.)
    CV+ (S7-2) - CV- (S7-1)
    Tool setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch on (IG), shift lever R position



NG
REPLACE TELEVISION CAMERA ASSEMBLY
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Reverse Signal Circuit (from Nov 2005)COMPONENTS (from Nov 2005) →