2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

  1. The radio and navigation assembly receives a reverse signal from the park / neutral position switch (automatic transaxle).
  2. The radio and navigation assembly receives a reverse signal from the back-up light switch (manual transaxle).

WIRING DIAGRAM

I102051E01

INSPECTION PROCEDURE


1. CHECK BACK-UP LIGHT
  1. Move the shift lever to the R position and check if the back-up light comes on.

    OK:
    The back-up light comes on.



NG
GO TO LIGHTING SYSTEM
OK


2. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)

  1. E119736
    Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation (P and R).

    OK:
    Shift Lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



OK
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3. CHECK RADIO AND NAVIGATION ASSEMBLY (REV VOLTAGE)

  1. I102045E01
    Disconnect the E57 radio connector.

  1. Measure the voltage of the radio.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E57-5 (REV) - Body ground
    Ignition switch is on (IG).
    Shift lever is moved to R position.
    10 to 14 V
    E57-5 (REV) - Body ground
    Ignition switch is on (IG).
    Shift lever is moved to any position except R.
    Below 1 V



OK
REPLACE RADIO AND NAVIGATION ASSEMBLY
NG


4. CHECK WIRE HARNESS (RADIO AND NAVIGATION ASSEMBLY - PARK / NEUTRAL POSITION SWITCH OR BACK-UP LIGHT SWITCH)

  1. I102046E01
    Disconnect the E57 radio connector.

  1. Disconnect the B28*1 or B25*2 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E57-5 (REV) - B28-2*1
    Below 1 Ω
    E57-5 (REV) - B25-2*2
    Below 1 Ω
    E57-5 (REV) - Body ground
    10 kΩ or higher

    HINT:
    *1: for Automatic Transaxle
    *2: for Manual Transaxle



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE


← Back Door Courtesy Switch Circuit (from Nov 2005)Display Signal Circuit between Radio and Navigation Assembly and Television Camera Assembly (from Nov 2005) →