2005-2008 RAV4 · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Nov 2005


CHECK TELEVISION CAMERA ASSEMBLY
I102050E01
  1. Disconnect the S7 camera connector.

  2. Measure the voltage and resistance between each terminal of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CGND (S7-3) - Body ground
    R - Body ground
    Ground
    Always
    Below 1 Ω
    CB+ (S7-4) - CGND (S7-3)
    B - R
    Power source
    Ignition switch on (IG), shift lever R position
    Approx. 6 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the S7 camera connector.

  4. Measure the voltage and frequency between each terminal of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CV+ (S7-2) - CV- (S7-1)
    W - Shielded
    Display signal
    Ignition switch on (IG), shift lever R position
    See waveform
    If the result is not as specified, the camera may have a malfunction.

  5. E119731E04
    Using an oscilloscope, check the waveform.
    Waveform 
    Item
    Content
    Symbols (Terminal No.)
    CV+ (S7-2) - CV- (S-1)
    Tool Setting
    0.2 V / DIV., 0.2 μsec. / DIV.
    Condition
    Ignition switch on (IG), shift lever R position


CHECK RADIO AND NAVIGATION ASSEMBLY (Click here)
← PROBLEM SYMPTOMS TABLE (from Nov 2005)Back Door Courtesy Switch Circuit (from Nov 2005) →