2005-2008 RAV4 · Service Manual DRIVE LINE

C1298/98 Linear Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The 4WD control ECU receives signals from each sensor to control clutch fluid pressure for limiting the center differential operation, which distributes torque according to the driving conditions.
DTC No.
DTC Detection Condition
Trouble Area
C1298/98
  1. When all of the following continue for 1 second or more:
    - IG1 voltage is 9.5 V or more.
    - Current is either 0 A or greater than 0.8 A .
    - Open or short occurs in the linear solenoid circuit.
  1. Wire harness
  1. Electromagnetic coupling
  1. 4WD control ECU

WIRING DIAGRAM

C128602E01

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. INSPECT ELECTROMAGNETIC COUPLING (4WD LINEAR SOLENOID)
C131916E01
  1. Remove the coupling connector.

  1. Measure the resistance of the solenoid.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 (BSF) - 2 (SLC)
    2.2 to 2.6 Ω
    1 (BSF) - Body ground
    10 kΩ or higher
    2 (SLC) - Body ground
    10 kΩ or higher



NG
REPLACE ELECTROMAGNETIC COUPLING
OK


2. CHECK WIRE HARNESS (COUPLING - 4WD CONTROL ECU)
C130947E01
  1. Disconnect the E67 ECU connector.

  1. Measure the resistance of the wire harness side connectors

    Standard resistance:
    Tester Connection
    Specified Condition
    E67-13 (SLC+) - Q1-1 (BSF)
    Below 1 Ω
    E67-32 (SLC-) - Q1-2 (SLC)
    Below 1 Ω
    E67-13 (SLC+) - Body ground
    10 kΩ or higher
    E67-32 (SLC-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE 4WD CONTROL ECU


← C1297/97 Steering Angle Sensor (from Aug 2008)C1299/99 Cancellation of 4WD Control (Nov 2005 – Dec 2006) →