C1299/99 Cancellation of 4WD Control
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
- If wheel slip continues, differential control will be disabled when the torque-distribution ratio of the differential clutch exceeds the set value and a malfunction in the output of the wheel speed sensors, etc. occurs.
- If a difference in diameter between the front and rear wheels is determined, differential control will be disabled.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1299/99 |
|
|
INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. CHECK TIRE CONDITION |
Check the size and condition of all 4 tires.
- HINT:
- This DTC is output when tire deformation or a difference in tire size is detected.
- OK:
- The diameter and air pressure of all 4 tires are the same.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at the speed of 20 km/h (12 mph) or more and check that same DTC is output.
- Result:
Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
