DTC CHECK / CLEAR
Troubleshooting · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


| CHECK DTC (When Using Intelligent Tester) |
Check the DTCs.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Read the DTCs by following the prompts on the tester screen.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| CLEAR DTC (When Using Intelligent Tester) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Operate the intelligent tester to clear the codes.
Refer to the intelligent tester operator's manual for further details.


| CHECK DTC (When not Using Intelligent Tester) |
Using the SST, connect terminals TC (13) and CG (4) of the DLC3
- SST
- 09843-18040
Turn the ignition switch on (IG).
w/o Multi-information display:

Read DTCs from the 4WD indicator light on the combination meter.w/ Multi-information display:
Read DTCs from the 4WD indicator light and the multi-information display on the combination meter.- HINT:
- If the 4WD indicator light does not blink, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.
- If more than 1 DTC is detected at the same time, the DTCs will be displayed in numerical order.
- As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown in the illustration.
- DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART" (Click here).
- If the 4WD indicator light does not blink, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.
Section Title
See Procedure
4WD Indicator Light does not Come ON
Click here
TC and CG Terminal Circuit
Click here
| CLEAR DTC (When not Using Intelligent Tester) |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch on (IG).
Clear the DTCs stored in the 4WD control ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the warning light blinks in the normal system code pattern.
Remove SST from the terminals of the DLC3.
Turn the ignition switch off.
- HINT:
- DTCs cannot be cleared by disconnecting the cable from the negative (-) battery terminal or removing the ECU-IG1 fuse.