2005-2008 RAV4 · Service Manual DRIVE LINE

4WD Indicator Light does not Come ON

Circuit diagnosis · Vehicles built from Aug 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

Refer to "4WD Indicator Light Remains On" (Click here).

WIRING DIAGRAM

Refer to "4WD Indicator Light Remains On" (Click here).

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B

HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (4WD INDICATOR LIGHT)
  1. Using the intelligent tester's Active Test, generate a control command, and then check that the 4WD indicator light operates.

    4WD control ECU:
    Item
    Test Details
    Diagnostic Note
    4WD Indicator light
    4WD indicator light ON / OFF
    Observe combination meter

OK:
The 4WD indicator light turns ON and OFF.



OK
REPLACE 4WD CONTROL ECU
NG


3. CHECK COMBINATION METER
  1. Inspect the combination meter (Click here).

    Result:
    The combination meter is normal.



NG
REPLACE COMBINATION METER
OK

REPLACE 4WD CONTROL ECU


← 4WD Indicator Light does not Come ON (Jan 2007 – Jul 2007)TC and CG Terminal Circuit (from Nov 2005) →