2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Automatic Light Control Sensor Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

The main body ECU receives the signal from the automatic light control sensor.

WIRING DIAGRAM

B128003E01

INSPECTION PROCEDURE


1. CHECK WIRE HARNESS (MAIN BODY ECU - AUTOMATIC LIGHT CONTROL SENSOR)
B128004E02
  1. Disconnect the E19 main body ECU connector.

  1. Disconnect the F2 automatic light control sensor connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E19-14 (CLTE) - F2-3 (CLTE)
    Below 1 Ω
    E19-14 (CLTE) or F2-3 (CLTE) - Body ground
    10 kΩ or higher
    E19-15 (CLTS) - F2-4 (CLTS)
    Below 1 Ω
    E19-15 (CLTS) or F2-4 (CLTS) - Body ground
    10 kΩ or higher
    E19-16 (CLTB) - F2-1 (CLTB)
    Below 1 Ω
    E19-16 (CLTB) or F2-1 (CLTB) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2. CHECK OPERATION OF AUTOMATIC LIGHT CONTROL SENSOR
  1. Replace the automatic light control sensor with a normally functioning one or a new one.

  1. Check for DTC.

    OK:
    DTC is not output.



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
OK

REPLACE AUTOMATIC LIGHT CONTROL SENSOR


← Light Control Switch Circuit (from Nov 2005)Door Courtesy Switch Circuit (from Nov 2005) →