2005-2008 RAV4 · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FRONT DIFFERENTIAL SIDE GEAR

C083566E02
  1. Coat the rotating surfaces of the differential side gears with gear oil.

  1. Install the 2 differential side gear thrust washers to the 2 differential side gears.

  1. Install the 2 differential side gears, 2 differential pinions and 2 differential side gear thrust washers to the differential case.

    HINT:
    Install the 2 differential pinions with the differential pinion thrust washers while turning the differential pinion.


2. INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT

C083565E02
  1. Coat the rotating surface of the No. 1 differential pinion shaft with gear oil.

  1. Install the No. 1 differential pinion shaft to the differential case so that the hole for the differential pinion shaft straight pin is aligned with the hole in the differential case.


3. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

C083567E01
  1. Using a pin punch and hammer, tap in the differential pinion shaft straight pin to the differential case.

  1. C083568E01
    Using a chisel and hammer, stake the differential case hole.


4. ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH

C083562E02
  1. Hold the differential pinion to the differential case side. Using a dial indicator, measure the differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0021 to 0.0079 in.)

    If the backlash is out of the specification, select an appropriate differential side gear thrust washer and adjust the backlash.

    Standard thrust washer thickness:
    Part No.
    Mark
    Thickness
    41361-28230
    1
    1.00 mm (0.394 in.)
    41361-28240
    2
    1.10 mm (0.0433 in.)
    41361-28250
    3
    1.20 mm (0.0472 in.)
    41361-28260
    4
    1.30 mm (0.512 in.)


5. INSTALL FRONT DIFFERENTIAL RING GEAR

C094319E02
  1. Clean the contact surface of the differential case and differential ring gear.

  1. Using a heater, heat the differential ring gear to 90 to 110°C (194 to 230°F).

  1. After the moisture on the ring gear has completely evaporated, quickly install the differential ring gear to the differential case.

  1. C070796E02
    Aligning the matchmarks, quickly install the front differential ring gear to the differential case with the 16 bolts.

    Torque:
    106 N*m{ 1,080 kgf*cm , 78 ft.*lbf }


6. INSTALL SPEEDOMETER DRIVE GEAR

C070795E01
  1. Install the drive gear to the differential case.

← DISASSEMBLY (from Nov 2005)INSPECTION (from Nov 2005) →