2005-2008 RAV4 · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE SPEEDOMETER DRIVE GEAR

C083559E01
  1. Remove the drive gear from the front differential case.


2. REMOVE FRONT DIFFERENTIAL RING GEAR

C083560E02
  1. Put matchmarks on the ring gear and the differential case.

  1. C083561E01
    Remove the 16 bolts.

  1. Using a plastic-faced hammer, tap out the differential case.


3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

C083562E01
  1. Hold the differential pinion to the front differential case side. Using a dial indicator, measure the differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.0021 to 0.0079 in.)

    If the backlash is out of the specification, install proper side gear thrust washers.


4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

C092887E02
  1. Using SST and a hammer, unstake the staked part of the differential case.

    SST
    09930-00010  

  1. C083564E01
    Using a pin punch and hammer, tap out the straight pin from the differential case.


5. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT

C083565E01
  1. Remove the No. 1 differential pinion shaft from the differential case.


6. REMOVE FRONT DIFFERENTIAL SIDE GEAR

C083566E01
  1. Remove the 2 differential pinions, 2 differential pinion thrust washers, 2 differential side gears and 2 No. 1 differential side gear thrust washers from the differential case.

    HINT:
    Remove the 2 pinion thrust washers and side gear thrust washers while turning the differential pinion.

← COMPONENTS (from Nov 2005)REASSEMBLY (from Nov 2005) →