2005-2008 RAV4 · Service Manual STEERING

C1551/25 IG Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The power steering ECU distinguishes the ignition switch status as on (IG) or off through the IG power source circuit.
DTC No.
DTC Detection Condition
Trouble Area
C1551/25
IG power source circuit malfunction inside ECU
  1. ECU-IG1 fuse
  2. IG power source circuit
  3. Power steering ECU

WIRING DIAGRAM

B128053E02

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (IG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and press the intelligent tester main switch ON.

  1. Select the item "IG power supply" in the Data List and read the value displayed on the intelligent tester.

    Power steering ECU:
    Item
    Item Description: Range (Display)
    Inspection Condition
    Specified Condition
    IG power supply
    IG power supply:
    Min.: 0 V
    Max.: 20.1531 V
    Ignition switch on (IG)
    10 to 14 V



OK
CHECK INTERMITTENT PROBLEMS
NG


2. INSPECT FUSE (ECU-IG1)
  1. Remove the ECU-IG1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. CHECK WIRE HARNESS (BATTERY - POWER STEERING ECU)
F100916E03
  1. Disconnect the E21 and A2 ECU connectors.

  1. Measure the voltage of the wire harness side connectors.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E21-5 (IG) - A2-2 (PGND)
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER STEERING ECU


← C1531/25 ECU Malfunction (+ C1532/25, C1533/25, C1534/25) (from Nov 2005)C1552/22 PIG Power Supply Voltage Malfunction (from Nov 2005) →