C1552/22 PIG Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
When a problem occurs in the system, the power source relay circuit is shut off to stop the power assist.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1552/22 |
PIG power source circuit malfunction inside ECU |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (PIG POWER SUPPLY) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and press the intelligent tester main switch ON.
Select the item "PIG power supply" in the Data List and read the value displayed on the intelligent tester.
- Power steering ECU:
Item
Item Description: Range (Display)
Inspection Condition
Specified Condition
PIG power supply
PIG power supply:
Min.: 0 V
Max.: 20.1531 V
Power steering in operation
10 to 14 V
|
|
||||
| NG | |
| 2. CHECK WIRE HARNESS (BATTERY - POWER STEERING ECU) |
![]() ![]() |
Disconnect the A2 ECU connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
A2-1 (PIG) - A2-2 (PGND)
10 to 14 V
|
|
||||
| OK | ||
| ||

