C1581/26 Assist Map Number Un-Writing
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The power steering ECU outputs this DTC when it determines that the assist map is not written in the ECU.- HINT:
- The assist map data is written in the power steering ECU to control assisting power.
- The assist map has 3 types. Select an assist map according to the vehicle country information that is recorded in the ECU.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1581/26 |
Assist map not written in power steering ECU |
Power steering ECU |
INSPECTION PROCEDURE
| 1. PERFORM ASSIST MAP WRITING |
Turn the ignition switch on (IG).
Connect the intelligent tester to the DLC3 and press the intelligent tester main switch ON.
- HINT:
- At this time, check that the P/S warning light is illuminated.
Select signal check, and change to test mode.
Wait for 3 seconds.
| NEXT | |
| 2. CHECK P/S WARNING LIGHT |
Check the P/S warning light.
Result Result
Proceed to
P/S warning light illuminates
A
P/S warning light blinks at 0.25 second intervals
B
- HINT:
- If the P/S warning light blinks at 0.25 second intervals, the assist map adjustment has completed normally.
|
|
||||
| A | |
| 3. CHECK DTC |
Check for DTC.
Result Result
Proceed to
C1581/26 output
Assist map write adjustment operation not completed 3 times or more
A
C1581/26 output
Assist map write adjustment operation not completed less than 3 times
B
Code other than C1581/26 is output
C
- HINT:
- If DTC C1581/26 is output, turn the ignition switch off. Enter test mode again. If the DTC is output 3 times in a row, replace the power steering ECU.
|
|
||||
|
|
||||
| A | ||
| ||
